Search results

Hi again Found a beko machine, tried to get the tacho shaft magnet off, but no chance. Tried to lever it off with a screwdriver but it just snapped into two pieces. Anybody any idea how you get these magnets off the shaft or how you would put one onto the shaft when re fitting?? Thanks

thanks zipper next step I will try the local recycling tip. too see if I can find a beko machine and give the attendant a tip in exchange.

Hi again sorry for late reply. Ordered a new tacho coil. Removed the old one and the little round magnet that goes inside the tacho coil then onto the end of the motor shaft, is in two pieces. I presume this magnet should be a whole piece ??? Firstly does this indicate the problem with...

hi zipper no I dnot have a multimeter, so I will take a look at the motor and see if anything looks ok with it. thanks

thank you for your reply zipper. a brand new pcb board was fitted a few weeks ago. and has been working fine since then. how can I chech the other things you have mentioned or is it a job for a repair man ? thanks gaz

hi all update number 2 turned off machine, turned dial too 90 degree wash, held in start button until light flashed turned dial to spin setting and held on start button until all the led lights were flashing on the control panel is this supposed to mean something ? turned off...

Hi again just sat and watched the machine and it spun very fast for approx 6 times and now the start / pause cancel light is flashing. Any ideas Thanks

Hi all. Just put a wash in machine on 40 degree wash. The program has started and water has filled up. Then the machine seems to be doing a very fast spin, then just stands still for a few minutes then a very fast spin again and again. Not sure what this means and why it is doing it ...

Hi again yes the pcb is the correct one. I have just tried putting it on a wash again and left it to run through the programme this time. And after a while the machine has flashing lights on control board The start/stop and the wash lights are both flashing together. Is this trying to...

I have been assured the pcb is for the correct model and that it should work fine. But yes there is always the chance it could be faulty. And in that case I will send it back. I have been told it may need resetting or programming???? Have you any ideas of my next step forward ??? Thanks

the machine dropped to the floor and landed on the control knob damaging the old pcb board.

hi all just replaced my pcb board with a used board. tried a 40 degree wash but all it did was click once but no water went into the machine. tried the spin cycle and works fine. can any body help thanks