Search results

Hi all I'm looking to lay a new patio in the area you can see in the photo below which I've started digging out level. It looks to me like the level of the patio is going to be dictated by the drain pipe I've circled on the picture but this pipework is only 75mm below the DPC. So....with a...

All, I'm looking to install a new sink into an existing waste pipe and I don't have any plumbing experience. My only sticking point is connecting the pipework from the bottle trap into the waste. The first photo shows the chrome pipework from the bottle trap and the 2 seals and nut that...

Hi all I have owned a Black & Decker router for a while for the odd DIY job. I now want to rebate some oak to replace a door casing so needed to buy a suitable rebate bit. Just been to the local stores & only found 1/4 & 1/2 inch shank bits where's all the bits supplied with my router are...

Can anyone give me any advice on what tools to use for putting up a field fence with wire keeping the tension nice and high? I intend on using round posts and want to have chicken wire along the bottom 3ft with a length of barbed wire along the bottom and a length of wire towards the top of...

Hi all I am doing some work on an old limestone cottage and I'm after some advice on methods and materials to use in finishing the walls? I will be doing some repair work to previously rendered walls and also finishing some clear stone walls which were external but, after an extension are now...

Hi all , thanks for reading, any advice will be gratefully received.... I have a Countax c600h ride on mower which wouldn't start (wasn't even turning over). I jumped the starter solenoid to see if it was the starter motor which wasn't working and it started fine but then wouldn't go in gear...