Search results

Thanks Nige but needs to be compression to match other fittings

Having trouble locating any and would be grateful if anyone knows of stockists. They are to be used for aesthetic reasons so bending not an option. Though looks like it's going to happen! Thank you

Old&Bold ....that was perfect, many thanks

Thought it was specific enough, the first responder understood.

Did you not read the original post?

Thanks but that isn't the problem.

It's a 90mm....that looks promising, sods law its too deep! Thank you.

All the shower traps I can find are, for obvious reasons I guess, very low profile. However because of pipe clearances and very limited room to work or make alterations, I find I need a deeper trap (like the photoshopped pic below), so that the waste exits around 90mm below the shower tray base...

Mrs wants an industrial style shower. I'm concerned that the attached pic setup will be difficult to balance hit and cold with the inputs directly opposite each other...or am I over thinking it? Also would prefer to use compression joints with 15mm galvanized steel for exposed pipework. Any...

Thanks everybody.... Now, where's the plastering forum.... :D

It's way too narrow to weld into the T as you say, when inserted into the compression fitting on the trap, it doesn't seem to go in far enough, as you tighten, it simply slides back out after 10 minutes. Think I may have a solution to ditching the flexi....pic attached...

Sorry I meant to clarify which end I was referring too by referring to the end you push into the adjoining compression joint. No, the male end fits neither the compression fitting nor the solvent weld T.

Wish I could. Space, other pipes, joists, it's not going to happen. Its flexi or rip it all out. I just need the poxy thing to connect.

I ordered a shower tray from Screwfix which was six days late arriving. Whilst waiting I connected the rest of the 32mm sink waste into 40mm shower waste into 100mm soil pipe. Solvent welded in, its done, cant be changed. All FloPast. Shower tray finally arrived and because of the usual fitting...

Doh! Never thought of that. Cheers china.

32mm sink waste needs to join 40mm shower waste and continue to soil stack. Cant find one anywhere.....am I missing something? Thanks

At present it has 110mm AAV, but I need to move this pipe and conceal / reroute between roof joists which are angled at 45 degrees. So I intend to remove 110mm AAV, extend vent pipe into loft space by using 40mm pipe, I can then add elbow to make it upright again enabling a 40mm AAV to function...

Thanks Nige but breaking through roof not an option....wife....aesthetics. ....will vent into loft space with 40mm AAV I think. Thanks for confirming AAV on angle won't work

Re routing a soil pipe so the vent will be concealed behind sloping ceiling plasterboard between the roof joists. Two questions. Will AAV work with the 110mm vent pipe at 45 degrees? If no, could I remove the valve, step down the 110mm pipe to 40mm and extend into the loft space. Would a 40mm...

Want to leave pipes exposed, industrial sort of look. Any suggestions for pipes, fittings?