Search results

I have added a self taping valve to a pipe, but it still driping I have tighting it up. But leaks were the hole was made. What can I add or do redtify this ? I have attached a photp

I have remove this stopcock under the kitchen sink , and replacing it with a new stopcock due to old one leaking, I am unable to drop the 25mm nut onto 25mm pipe. It seem too tight I am even bought another stopcock but the same problem. The 22mm end fits ok. The orginal nut fits on ok. Any ideas...

My mains stopcock under the kitchen sink is leaking, so I want stop the outside mains water supply what stopcock do I need to lock it. See picture the orange in the pictue be turn off. I bought Stopcock key 222mm but does seem open Any ideas would be grateful...

I want to install a cooker hood as shown below but on the wall the coving seems to be in the way, I will be using the the cooker hood as recirculating hood. Do I need to remove coving to make it level to the ceiling. I pplain to remove some of the tiles as well. I would like advice if I...

Any ideas on the best way to remove biro marks from beechwood ?

I have installed a new beech worktop but while doing the kitchen, the worktop as shown have mismatched colours , what oil can I use to make them the same and any ideas will help. ? Thanks Debo

I am currently in the process of installing an integrated dishwasher in the kitchen, my concern is to do with with drain hose connection, because the washing machine is currently using it, and is only adapted for one hose. As the waste run horzontally on the floor via waste pipe behind the...

I have Glow worm ultimate with megaflo, the water pump was replaced and the pcb in the boiler were replaced as they seem to be faulty it now working ok now with hot and heating. My concern now is that water pump seems to be on all the time even when the thermostat is off for both heating and...

I need to paint the wall as shown on picture below a patch is shown, what primer can I use to paint this area and coat it with the new paint, so that overlaps do not show. I know if I just paint this area it will show that patch or I scap it an more than I would have to do the whole wall...

Hi, I installed a towel radiator as show in the picture http://i.picresize.com/uUz, my problem is that I used compression hoses as a last resort temporarily due to the width not be accurate and pipes just a few centimeters off and the pipes been too close to the wall. I now that using these...