Search results

Yes l he did all the ways to the stack. And it was clear. Could it be something else ?. thanks

Hi all I need some advice on the following. So in my flat I had a slow draining kitchen sink has been fine for seven years but been slow for the last 6 months. Tried all the products I could and no joy so called in my trusty plumber who has done work for me before. He rodded and cleaned out...

Also to add the ceiling is higher than 2.25 meters from the bottom of the bath so think the lights would be in zone 2 by about 4 cm. Would it be ok. Thanks asylum

I think I can use these in zone 2 for my bathroom http://www.gil-lec.co.uk/products/Energy+Saving+Products/Energy+Saving+Lighting/Low+Energy+Indoor+Lighting/Energy+Saving+Downlights/Low+Energy+IP65+11w+Firerated+Downlight+PC/1441315039 But one of them will be border line zone 1/2 in terms...

My flat has the old lath and plaster ceiling and I have been up in the loft for the last day or 2 fixing some new wiring for lights. I had to vacuum around the light holes to minimise dust and when I did this I found there is a thick layer of soot under the insulation. I think it is from when...

Ok got a look at some 240v ones today and they are different much bigger connector and they have an earth connection. However I have decided not to fit them as after looking at the job and the work involved in taking out part of my old ceiling and probably replacing it with plasterboard squares...

Thanks for the quick reply. The unit was a 12v but I changed the connctor for a 240v bulb however in the instructions it says class 3 low voltage luminaries must not be connected to a 240v supply. Is it still safe to connect it.

I bought some fire protected downlights to put in a bedroom. I wanted to get come with GU10 connectors so I could use the megaman dimmable energy saver bulbs. They shop did not have any but the manager just told me to change the 12v bulb connectors with the GU10 connector cables he gave me and...

My washer dryer is well not working right on the drying cycle. It only happens some times but it gives an error code. The following lights are flashing delay easy/iron 600/122 spin and lock light and the water pump keeps pumping. Can anyone tell me what this fault code means. It only happens...

I have a master plug 10 meter coiled extension leas with 4 sockets on it. It has built in thermal cutout. Is it safe to run a 4 way surge protector and some other computers ups etc off it. Thanks Asylum

I think I have solved my problem. I am going to take a spur of a socket connected to the ring. I am doing this to get power to the other side of the room I need to power a ups which will have 4 computers on it. I will also have a printer connected to a 4 way extension and a broadband modem. Is...

I am not sure it is about 10mm accross. But amp rating could not tell you. It is supplying power to 1 double socket. Asylum

Its 27amp cable I believe looks the same as the cable I have for my socket. It a weird setup. there is just this one socket powered of that single breaker consumer unit. this is what it is connected to Wylex 104 1 way 45 amp DP insulated consumer unit Asylum[/img]

Ok I have a double socket that is connected to the mains through a wylex 45a breaker it has one trip switch on it. This socket powers a water heater for hot water in the flat. Its a small plug in unit. My question is can I take a spur off this box and have a second double socket coming off of...