Search results

New build so can open fire as nothing to open lol. I have got a new installer to look at it and he is advising it's to small opening for this burner and should never have been put in. as the people that put this in were not hetas I have taken this issue further to try and get some money back. so...

The manual also doesn't give me distances around it just ones for distance from combustible materials

There is a flue linner and this was installed by a company but not so sure how well they know what they are doing now. so I want to bring back to standard and get it signed off. No plate fitted yet but I have a steel sheet provided with the stove so no vermiculite either as not fitted...

It is tight that's why want to bring it further out of the fire place

Yeh it's a ekol crystal 5

Yes

I have a multi burner and where the flue pipe attaches to the burner it sits at an angle due to the construction of the chimney it's the only way I can do it. question is will this be ok? The flue sits in the burner spout only by say around 5 mm one side and obviously a fair bit more the...

Lol so ya reckon they said just dangerous to get me to give them to them? And most likely they are all good to lay for patio?

I have piles of old patio slab in the garden from when moved in. And I want to reuse them. When I had some asbestos tiles removed from our house they mentioned old ones may contain asbestos as they are heavy concrete ones not like the ones in wikes etc now. Just wondering if should get these...

A

Yeh I had some taken away before so have someone who will take them. Just wondered if the water damage makes them more dangerous as the other ones that were removed were dry and just came up on there own. These ones are mainly whole as well just water damaged and two have few bits broken of them

Hi I have removed my old sink and my kitchen floor is asbestos tiled. Under the sink they are water damaged. A few have crumbled edges and the rest are whole but bowed and no longer stuck down. What's the best course of action? Wet down and clear the area into a bag or is this not a good idea?

Next question is I have wylex type 1 mcbs is there an equivalent that will fit the consumer unit now?

Ok I think if I swap the mcb for a 32 amp then I have protected the cable as said under method 100 it's 34 amp rated. So ill change this and also feed the appliances from the same outlet. So the final thing is the flex on the hob it looks like it's rubber and heat resistant so does that mean it...

The instructions say 4.8kw on 32 amp fuse for oven and hob 6.2 kw on a 30 amp fuse and has a lead pre wired. What the best way to install these, as before I have a 6 mm t and e supply from 40 amp mcb to cooker outlet with two 6 mm t and e to each appliance. Would this work if I took one to...

So I used to have a free standing oven with hob on top. It was fed from the board on a 40 amp mcb in 6 mm cable via a oven outlet plate. I have now got a separate double oven and hob. Can I take two 6 mm cables from the oven outlet plate one to each piece of equipment? Leaving the 6 mm supply...