Search results

Thank you for the reply. I should of stated bottom picture is not my unit. It just shows the connectors on the back of the heatmiser slimline v3. I am yet to connect mine. So I guess I'm asking how I swap the cables from mine, into the one marked n l a1 a2. Thanks

Hi All, I have a center manual thermostat, with the wiring schedule as shown below. I want to swap for a heatmiser slimline v3, How do i swap the wiring over please? What confuses me is the mention of two neutrals. I have 3 wires - live, neutral and what i assume is switched live. Which is...

Thanks for the reply. Boards off tomorrow then! I'll put a socket faceplate on the existing spur at the uh1 and add a new box running 4mm from the existing boiler spur. This will mean 4mm from board to boiler switch and onto uh1 switch Thanks Mike

Thanks for the quick replies. so my wiring logic for boiler enable is sound. To rectify the supply issue. Does putting boiler and ufh socket ring on same rcd work? Or do i have to take down boards and put cable between uh1 and boiler fused spur? Thanks mike

Good morning. I have wired a new conversion with the assistance of our electrician but am a little stuck wiring the boiler and our jg ufh system. We have a jg uh1 wiring center which we have wired for mains on the downstairs ring. Our boiler is on separate supply. We have installed...

Good evening, I'm 99% set on buying a powermaster 10 or 30 for my new build I am workin on. I have installed flush mount door contacts into all 4 external doors and wired these back to panel location. My question is, the 30 unit lists 2 hard wired zones. Are both of these suitable for...

Hi all, Hoping someone can advise please. I have pp to convert a barn and am sorting out builders etc. One has commented that the existing tiles that we are supposed to reuse have no nail holes. They also have two fairly small nibs that they think may not be good enough for modern batten...