Search results

You're absolutely right... There is a possibility that was never working, since install, I never had reason to check it.... So that's the next issue to sort.... Best get the multimeter out again!

Thanks, worked out an alternative. Going to make a regular frame and glaze it each side, and have a glazed door in the middle..much easier than chopping up doors.

Thanks everyone, finally got a chance to have a look. Turned out to be the synchro motor on the motor valve £9 and a very uncomfortable half an hour in a cupboard... But all working again!

Thanks, its the Deanta Seville in Walnut... they do 2040 heights which would work... and i was thinking of getting the 826 wide for the centre... and they dont make the singe panels thin enough so i was thinking of chopping a 926 in half for the side panels since the rough edge will be up...

Thanks, i wanted the side panels to match the door.. so thats why i thought buy another door and chop it in half. The doors have a decent amount of solid wood around the edge so Im thinking it should be ok?

Hi, I want to put a door (where an old pvc door used to be) between the hallway and porch. The floor is level and the dimensions are something like 2050mm high and 1740 wide. Im trying to have a central door and 2 side panels. I want the door to match all the other doors in the house and the...

there are 2... i presume one for central heating and one for hot water, i think i have identified which is which. (one gets warm when central heating is on)

Thanks. Will check that. Will set nest to boost. What is the chain of command? Nest calls for heat, valve opens, thermostat on cylinder says ok, boiler fires?

Hi. Yes I have a multimeter...I could give it a go? Haven't used it before.... What should I check please?

Hi. Please help me identify the fault. I have c/h but no h/w. I have a green Star ri boiler and a nest thermostat. I have a thermaq cylinder. If I call for hw boost or schedule hw heating the boiler doesn't fire up, the motor valve doesn't open. If I put heating on and manually open the...

Sorted it.

thanks both... at the moment it is the switch that turns all 8 lights on. i thought the cable the other side of the room had nothing to do with anything until i disconnected the black wire from it and 1 set of lights didnt work.

Hello, I am trying to replaster the kitchen, and the wiring is all over the place. I am trying to tidy it up a bit, but I am confused about how it is wired. I have two sets of LED lights A and B, B are in a more recent extension. I have labelled the wires I have, and done a...