Search results

Hi New room being created from 6 x 5m garage. Rear wall, shown in green, is below ground as 3 story. Steps come down the left side to the front drive. All insulated, Rad to be added. Door added shown in image at back right of new room. Q - Best place to put radiator? Q2 - There is a radiator...

I am in the house, and they have just supplied an email saying it is ok, from GTC - GTC is part of the BUUK Infrastructure Group, the leading provider of multi-utility networks in the UK, employing more than 2000 people and operating networks serving more than two million homes.

Hi I had my new build house professionally snagged. Among the pickups was the height / location of the gas box on the outside of the house. I have read the 500mm guide. However, its about 20cm from the drive tarmac. Taylor Wimpey saying it's fine according to the site service provider company...

HI What brand recommended Do I have to prep in any way? 1 coat stuff or 2 coats? any help for amateur appreciated Thanks

Hi Will get it professionally fitted, but wondered if one is better than the other on concrete - is one better than the other over anything? Any particular underlay recommended, also same for the flooring itself.

Thanks all

Ceramic type tiles?

Are they vinyl tiles?

Suggestions and why?

Thanks

Hi Open plan living room / kitchen. New flooring throughout and new kitchen to have fitted. which is best to have done first? The room is basically an oblong with stairs (Thinking flooring under kitchen or just to kick strip etc made me ask) Thanks

Thanks

Try again. It won’t tighten up. It won’t come out. Please don’t say it should do or you can’t see why etc.

Ha ha Terry. You had me going then for a moment. I believed you couldn’t understand what I had written. Nice one.

That’s the thing, should I not be clear, they won’t tighten up even though you can’t see why, and me cutting them is because they won’t come out.

Spent about an hour trying all sorts to tighten them up. Managed one, but the other loose. If you look carefully you see that the locating part is sideways on the thread. Managed to straighten it at 90degrees to the thread but just the same. Hence my question about changing them

Hi Unable to tighten the fittings that hold the seat in place. It’s the type that you press 2 buttons to release from the pins they locate on. Is it possible to change these. Not sure how I get them out. Thinking dremmel the screw and let the part inside the toilet just drop. I have seen some...

Hi My partner has a LG heat exchanger? Therma v It tripped out recently and I have reset the trip. She was having building work at the time. All powered up and it has a controller fitted where her tank etc is. There is also a remote stat downstairs on the wall for rads etc. My question is...

Opened it fully This compressed the plastic Solved Thanks All

No movement that I could feel. Was thinking of squeezing the right hand ends together. Will take another look. Thanks