Search results

Enter engineer code into alarms panel, cycle through to volume control, then adjust the option that suits

In engineering installation manual. See attached page

thanks for the suggestions, i played around a bit with settings and tried use main sounder in volume settings. that did the trick, i thought that meant the external sounder when i first went through the settings. cheers

looking for some assistance with a small issue i have. i recently self installed the enforcer home control + panel, 3 PIRs, 2 door contacts, remote keypad, and delta bell. everything generally works fine, my issue is the volume of the tones from the main control panel. i have tried adjusting...

Hi musszzy, the exit timer is set for 20 secs. But when exit mode is final door on area A, the timer doesn't seem to matter. The alarm exit tone and message saying leave via exit route remains until the door is closed. On area B and C, which are set to timed, 20 secs, the alarm never sets. Says...

Thanks all for your help so far. I have one last question. I still have it setup for bench testing, will be getting fitted end November in new house. Fine tuning the settings now. I have areas set as A - full set, 3 pir and 2 door contacts. B - night mode, 1 pir and 2 door contacts C -...

At the moment I am setting it all up,on the bench. Then fitting to house later. But the battery does need changed every year or two, so opening sets of the sounder. Does closing silence it? I have only unplugged the sounder from the circuit board. Removed then learned from the unit again, I just...

Thanks handymanjo, i will experiment with it tomorrow, but adjusting sounds per Area sounds like the perfect solution. Your suggestions are just about what i need to, all, night time(just doors) and garage only. Re bellboy, so there is no way to open the bellboy without setting off the sounder...

hi looking for some advice with a few queries I have. I am self installing a pyronix homecontrol+ panel, 3 PIRs, 2 Door contacts, wireless Keypad, delta bell. I have installed a few wired system in the past so have a basic understanding of what I need. I have the system setup on a bench to...