Search results

He stuck the analyser in the flue - but I'm not 100% sure. I will ask him. Many thanks

Thanks Ian My guy is a local independent Gas Safe engineer. He's been servicing my boilers and doing my Gas Safe Certs for ages. He just spent half a day and wasn't really sure. He thought it could be something like the gas valve or mix after everything else didn't make a difference. Thanks...

For around six months my Vokera Vision 25C has been making a short whistling noise when the hot tap is turned on. It started intermittently initially but now its everytime hot water is called for. I can’t recall any works to anything when it started. The noise lasts for two seconds max and I...

FFS... Just found this lol. But the advice was spot on! All Good.

Thanks again! Really appreciated.

Thanks Ian, your a legend... So I now have it connected to the port, with the tiny hole, surrounded by white in the photo below:

Here is what the inside of the tube - that it is connected too looks like... Still (even with the name) cannot find reference to this in the manual (linked above)...

Thanks for that... I've hunted through the instructions and cannot find this. It now looks like the photo below. I have connected it to the only projecting metal that does not house a brass/copper looking screw. At the base of the projecting metal stalk it is attached too is a metal looking...

Thanks... What is it? What does it do??? I take it that is the left hole in the photo below? Does it matter that it seems to have been disconnected for ages? The one on the left here?

Got it sorted and it works a treat! Many thanks. I even emptied the sludge from the condensate trap as it had directions printed on it. One quick question I took photos upon opening the boiler - before I had touched anything. Whats the rubber tube that appears to be hanging around for (see...

Firstly I realise this is Nest installation post number ten billion - I've looked around online for ages. My new house has a Vokera boiler and I have spent most of the morning looking at wiring diagrams and scouring the internet... There is very little on Vokera and Nest. I have removed my...

Thanks for that - I'm just keen for it to look good... I might see what I can do as I don't think I can make it any worse and if I do have to re-lay / sew it its only small.

I wonder if anyone might be able to help me resuscitate my lawn. I have recently tried to revamp my lawn - after a shed and patio install saw it trampled to near death. I have thus far: > Mowed it short > Scarified it But ahead of sewing new grass seeds I wanted to aerate it. I cannot get my...

OK So I cleaned it all out. Put a cap on and paved over it. Sorted (I hope)... Now if only I could remember where it was... Thanks for all your help! PS I did put the screw cap back before covering it all!

Thanks Andy So I can just seal it with a removable lid to keep it clean. Mark where it is and put the paving back over?

Thanks for that - so should I clean it out and put a grid / drain over it? Or plug it off and cover it again as - so far as I can tell - there is no issue with rainwater drainage?

Thanks for the replies. It isn’t water stop valve access - that’s away along the drive next to the water meter. This is also much larger. I was thinking it could be a soak away... Should I bury it or put a grid it? Will water drain down and around that access plug?

Whilst cleaning my block paving I lifted a block to repair it where it had sank. Underneath I found this bit of 160mm waste pipe. It appears to have a small screw top access port inside it. It can be seen on the attached photos. It had no cap or cover. I am almost certain that it is not the...

Whilst cleaning my block paving I lifted a block to repair it where it had sank. Underneath I found this bit of 160mm waste pipe. It appears to have a small screw top access port inside it. It can be seen on the attached photos. It had no cap or cover. I am almost certain that it is not the...

Driveway