Search results

  1. S

    Hive heating only receiver wiring - Earths not need?

    Hi I have recently wired up a Hive receiver and is all working fine. However, my boiler is being fed from the fused switch via the Hive so I have twice as many cables (live, neutral and earth from the switch, and neutral, common, heating on and earth from the boiler as well as the link between...
  2. S

    Advice needed for swapping Heatmiser RF receiver for Hive single channel receiver

    Hi. I would like some advice on swapping receivers. I currently have a Heatmiser Neo wireless setup but have recently purchased a Hive active heating single channel stat pack as I am after the app functionality. I would like to swap out receivers and assume it is a straight swap looking at the...
  3. S

    Baxi Solo 24 HE Ignition lockout. Replace condensate trap?

    I have been having an ongoing issue with ignition lockouts (Red light ON, Flame light OFF, Mains light ON) on my Baxi solo boiler and according to the service manual fault finding flow chart, looks likely to be the electrodes or condensate trap. I took the cover the boiler yesterday to find...
  4. S

    Baxi Solo HE 24 ignition lockout issues.

    Hi, any advice given would be much appreciated. It started last August when all the sudden I had the red ‘lockout’ light on my system boiler (Baxi Solo 24 HE). I would reset it and it would be fine for around a week then would need resetting again. I put up with this for around 6 weeks until I...
  5. S

    Swapping out Switchmaster room stat for digital stat. Advice needed!

    I'm thinking about swapping out my old dial Switchmaster room stat for a digital one. I have an open vented system with a Baxi Solo 24 HE boiler controlled by a Drayton 241 programmer which controls CH & HW separately. I was thinking about going for a Honeywell DT90E which would just have the...
Back
Top