Search results

Had a browse through my search results and not been able to see what I'm looking for, so apologies in advance if its already been covered and I've missed it. Back story, dewalt (776) drill is playing up (just cuts out when in use) however the batteries are good. Bought an adaptor to be able to...

Thanks for this, it makes some sense now. I'd seen adaptors listed but hadn't realised what they were for, I'd agree with you're thinking that one wouldn't be of use to me but good to know about.

No markings on it, also I'm assuming my original one is a genuine Karcher.

Yes the yellow one is my original with the same sized lugs as all my other Karcher bits and bobs. The Black one is the one in question, it looks identical in all other aspects except its male and female lugs being smaller. I'll probably cut down the lugs on the water broom/patio cleaner head as...

An extension piece that came with a used hose&trigger I recently purchased, although looking the same (as the other one I have) has different sized "lugs" ie it will connect too my existing K2 type triggers/extension but nothing I have can then, be connected onto it. Anybody able to throw some...

Been using this little unit a fair bit now, fairly early on it became apparent that the 4m hose was restrictive. I've since bought a s/h 6m hose which had a trigger and an extension included. The extension although looking the same as the one I already have differs, the lugs are smaller @12mm as...

That could well be mystery solved, many thanks for the prompt reply. I did find a manual as I was looking for the part nos for the O ring on the pressure line but do confess to not reading through it, as I was then assuming it was supposed to work the same as my other one.

been trawling through a fair few threads and not finding anything with the same symptoms, so apologies if it's been covered before. Picked up a used lightweight B102 in a bid to not have to drag out the the old faithful K2 (which is still going strong after many years) to clean the car. Anyhow...

The more I'm reading up on it, the more of a red herring it seems. I'd say it was installed as double pole with the link off and as you say Z1 the tamper zone by default. Now I know I can reclaim a zone by going DEOL I'm tempted, are the resistors easily obtainable? and while I'm asking. Are...

Link is not on pcb and no resistors, pretty much just replaced the previous ancient faulty kit using the existing old 3 pair wiring. It has been working okay over the last few years with the occasional alteration here and there but todays mods have done something, probably to the programming...

So, DIY'd my alarm some four years back. All has been working okay, today I altered a couple of things. On exiting engineer mode I have a "01 Tamper fault". The fault is present with my tamper wiring, without any wiring and with a direct link across the zone1 terminals. I suspect I have...