Search results

Thanks again. It’s a good bit of kit, but the GUI is a thing of the past. Simple to use if you know how but not very intuitive!

Sparkymarka, one last question if I may... How can I rename C to garage? Thanks!

Resolved!! I changed the master manager code through the engineer menu. I assumed that this menu was just to change the code, not the areas too. Thanks for your help sparkymarka! (y)

It won’t let me add C to the master either :mad:

I can’t set C using master code, also I don’t see the master code in the edit users setting, so I can’t seem to add C to master. Is that in another menu?

Set point sets show A, B, C and D.

A and B. Using the master code to edit users won’t let me select C, just A and B.

Ah, no, just a standard user code.

Editing the input with engineer code, adding the zone with master code.

I recall activating the zones when I first installed and renaming them. Can’t find anything like that in the engineer mode now though.

Hi Sparkymarka Thanks for the advice. Have checked all inputs and C isn’t assigned to any other input other than the garage.

Hi all, some advice on programming my Enforcer would be appreciated if someone has the knowhow. I managed to programme two areas when I installed the system a few years ago, but now I’ve bought a sensor for the garage and I’d like to add a new zone (C) to be always set (when A or B are not in...

Hi sparkymarka. I managed to fish out that post you mentioned. Turns out that the output type for the bell had been changed to 19 from 14. I must have changed this without realising at some point when I was trying to delete or add the bell when I moved house. I also added some masking tape to...

Already looked and couldn’t find anything linked to the bell sounding when the system is unarmed. Very odd.

Thanks sparkymarka. If that’s the case then a full reset will probably be quicker and less painful than checking all the factory defaults.

Thanks for the video Fozzy. Interesting that this shows the input type as entry delay rather than final exit. I wonder if this will make a difference...

I forgot to mention, when the door is closed, the siren stops! But... after deleting the input and learning again to see if that made any difference, the siren went off when the door was closed, and turned off when the door was opened! Only the bell makes a racket, the panel doesn’t do anything.

It’s the mini wireless contact.

The sensor for the door battery is new. The bell battery hasn’t been changed since I installed it. The log mentions “wirls tamp restr” and another tamper alert, but I think this down to me opening the bell to disconnect the power.

Hi all. I’m looking for some help installing a door sensor for a Pyronix Enforcer and would be grateful for any advice. I set up this system about 4 years ago and have not had any issues. Now I’ve tried installing a door contact and when ever the door is opened, the siren sounds. This...