Search results

Morning Guys, Got a weird issue when part arming the above, only one area set on the alarm which covers all sensors, full arm works a treat no problem, when part arming, the sensor that is omitted on the part arm works as it should, but another sensor which is in the living room is also been...

Guys, Hi have just installed a Pyronix DeltaBell + to replace my old belle, this works no probs, I have used the old belle as a second bell box, it was my understanding you could wire in bell +, bell -, bell trigger and strobe all in parallel and the tamper in series, When I do this all is...

Guys, I have got a QVIS Universal NVR running the latest Cortex software, there are two Qvis PTZ cameras attached to it, and I have added a further 3 Hikvision cams, the hikvisions work fine no lag on preview or playback, but the Qvis PTZ seem to be dropping in and out of connection, the...

Guys, I have a condenser dryer which now after doing a cycle, seems to produce a lot of water at the front of the dryer below where the filters are, I thought it was the pump at the rear, so checked all that and even replaced it with a spare, that seems to do its job and pumps water up to the...

Guys, As the subject says, I have Home easy ultimate sockets, boiler switch and light switches. I was just about rip them all out and replace them with some lightwave rf kit. Then I thought can this system be made smart, spotted a few things that will say it will work with this kit, but does...

Guys, I am trying to get three Hikvision IP cams working on a Oyn-x NVR, I can discover all the cams via SADP tool, set the correct IP and login details, they work a treat through a browser, If I go onto the NVR and add them manually it fails with camera is offline or login details are wrong, I...

Guys, The mother in laws dryer is puddling at the bottom at the front where the filters drop in, it looks like the pump is not pumping the water to the top catch tank, took apart the rear lower tank where the pump and float sit and cleared out all the fluff, I ran a cycle with it off, and...

Guys, I am just about to swap an old wooden fence that is situated between two driveways, the idea originally was to put in slotted concrete posts with the usual gravel board between and fence panels, but was thinking I may as well put a lean to roof over the driveway while I was at it, usually...

Guys, Got a glitch with the above system, when the system is part armed, which basically just turns off the landing PIR, it sets fine as part arm, you can walk around and its sets and doesn't go off, if you leave the system armed, and say get up in the morning the alarm goes off triggered by...