Search results

any recommendations. the place im getting the floor is charging £10 a litre!! bit rich for me! what should i use and where should i get it? Many thanks Jon

already done the full power thing. thanks anyway. yes the lockshield is open too :(

hi all, i have a non pressurised system. boiler downstairs, tank and pump upstairs. i have no TSV's in the house - all are pegler standard valves. One rad in the kitchen is cold the rest are very toastie indeed! the pipe going into it is hot but the pipe coming out is cold. i have...

answer found, please delete, thanks.

problem is that the step part is about 1 - 2" higher than the floor ? :?

hi all. I going to be installing solid wood flooring soon in my living room / hallway. the house has a concrete floor which is nice and dry and in good condition. in the hall the front door step protrudes about 2 - 3" into the room. the hall is about 1ft above ground level. The...

brill. thanks, so the minumum i can buy is 9.5m? sorry for the newby questions

thanks. how much should the steel be? jon

hi all. I am looking to take out a 4.5 load bearing wall, to be replaced by a UB. the wall coming out is single brick. I know there are lots of factors involved but roughly what shoud i be paying for it to be done? Thanks in advance. Jon

got it. the unit only sends a signal every 10 mins once its fired up.... thanks all. jon

Hi all. I have had a Salus RT300RF fitted today. all was great until the programmer stopped then restarted later for my evening cycle.... then it seems that the sender unit wouldn't connect to the reciever unit.... the only way i can get it to do it is to turn the heat down on the stat to...

thought so - basically its wrong isnt it! doh!! ill get that changed then! today i manually left the DHW open - no prblems all day! got to be a pressure issue!!! Thanks for that big beak07, I'll try it, see what happens :)

thanks. isn't this what happens when both DHW and the heating are on? it will run, even for a couple of hours with both valves open, then when they both close again after a short time it goes off. I'll give it a go anyway, ta :) I agree with the above post too! thanks everyone! anyone...

im gonna have to resurrect this one from the dead im afraid! I FINALLY got this lot sorted out. room stat, tank stat, second valve in place of the stopcock. Now i have a new problem!! :evil: the boiler goes out after the timer goes off. seems like there's a boiling sound from within the...

central heating

the plug socket seems to be fine. it is quite intermittent. it usually happens as the water starts to get hot. are there any other safety features which could cause the machine to shut down?? Jon

hi folks, my dishwasher is having a bit of a strop! It starts its cycle, counts down, and then stops halfway through a cycle. the display turns off and wont turn back on. I leave it for about half an hour then switch it on and its fine. it always has water inside when it stops, (usually about...

lol. this is probably why i'm booked in for eye laser surgery tomoro!!! the boiler has only 3 wires also! on the wiring picture its the grey wire on the right. with black, red and earth coming from it. Jon

the pump only has the 3 wires, live neutral and earth so guess there is no boiler over run. i have a horstmann centaurplus c27 programmer so will follow the wiring diagram on here http://www.tlc-direct.co.uk/Technical/DataSheets/Horstmann/Pics.pdf and get the second zone valve to make it...