Search results

Not tightened the screws up enough by the looks of it!!!

Sorted!!!! After reading all the helpful replies to my problem I thought I must be missing something but I had covered everything. I decided to start again and found the fan had vibrated lose and come adrift so the airflow was not as should be. Put back in place and all seems good. Thanks for...

Jubilee clip is to stop the throat in place on the peg. It the past the plate as dropped, this makes sure this can't happen. Fire lights and sticks to light , no problem. Been using this boiler over 5 years, just started getting problems. Can only put it down to a bad load of coal at this moment.

It all looks the same from what I think is good and bad, shiny black.

When i have the problem in a morning the water is cold so I no their is a problem. When I get to the boiler the fan is running so I open ash pan door and its dead. Two shakes on declinker and you get the fire bed to the front but just glowing, its not boosting up at a full burn. Pop 2 sticks in...

Anthracite, grains. This morning good news is the boiler working as normal. So I've put a bag of coal in from the batch that I was having problems with. If its out in morning it will point a finger at a bad load of coal.

Hi all, thanks for the replies, boiler taken to bits to clean, including the secondary air vent at rear, fan removed and cleaned. Regulator plate got a jubilee clip on it to stop that moving. Heat leak is red hot when boiler working properly. Cleaned airway with soot breaker. Burn was on its...

I have a Trianco TRG45 gravity feed boiler. Its been working fine but now goes out regularly!!! It does not boost back up to full burning from slumber. If the boiler has been on slumber due to the water being at temperature when a call for heat is made the burn will not boost up again. A few...