Search results

Cheers magic. You have all been very helpful (y)

Thanks magic. What were you covering? Also was it out of level much? Did you use many bags?

Thanks Conny..... Yes I am going to need alot more bags :eek:

Hmm good point. It is 3 metres wide by 3 metres long..... So whatever that is :D

Thanks Mike. Yes I suppose mixing 4 bags in one go might get a bit heavy lol Do you have to mess with it much once it is poured? Or just leave it to do its thing?

Hi all Apologies if this is in the wrong forum. I am going to attempt to level my shed floor. It's a combination of tarmac and concrete flags. All in good condition but just looks odd. The area is 3 metres squared. I am thinking of using mapei 3240 for this job which says it covers 6 square...

OK cheers (y)

OK cheers for the info

Hi all I need to extend the flue on my bolier either about 3 metres horizontally or I could potentially go out through the roof of my new car port. Firstly are the flues extensions bolier specific? And secondly is this a DIY job? Cheers in advance

Hi Folks, It is basically a 9 foot wide lean to that is 11 foot long. Gonna turn it into a shed eventually. Struggling for headroom so want rafters as high as possible. Would the fall in the bubble picture be ok for felt? it drops about 2 inch over 9 foot. Cheers all

yeah fair do's i was just being lazy. 4x2's with a max of 450mm centres it is then :) Whats this OSB board all about? OSB vs PLY? For the roof.

sorry to be a pain....... is there anyway i can use 3x2's? for the joists? 9 foot span/depth. Just find them a bit easier to handle working on my own. Can i put a brace down to centre maybe?

OK cheers, been very helpful I think i know where to start now. I will draw out a rough sketch and post it, see if it is somewhere near ..........it will not be pretty :eek:

Brilliant info cheers. The spacing of the joists was going to be my next question :) So it is 11 foot in length and 9 foot deep..........could i get away with 4x2 joists? If spaced correctly?

bloody hell never expected this much response (y) awesome.......i have lean-to envy now so.... ok the joists need to be notched into the wall ledger/plate? Are the ledger and plate the same thing? As in the bit i need to bolt to the wall? I am going to put a wooden roof on it, would 1/2 inch...

hi all, I am new on here so hopefully this is posted in the correct forum. I am thinking of building a lean-to (that might turn into a shed at some point). It would come off the side of the house and would be 11' long and 9' wide. I am thinking that i need to bolt a 4x2 to the house to carry...