Search results

  1. P

    CCTV Cable advise

    Me and the neighbour have fitted cameras on our houses, I need to run a CCTV cable to link upto his DVR, would the cable (listed below) be suitable Your assistance would be helpful, many thanks in advance Phill RG59/U Data Coaxial Cable 75 Ohms coaxial cable for use in high...
  2. P

    Advice on a cheap CCTV recorder

    Hi folk, Could somebody advise on whats a good cheap recorder with a 250gb hard drive, currently have 1 camera but may be using a second one. Your thoughts would be greatful
  3. P

    Worcester 28CDi Hot water issue

    Hi people, I have had the boiler for nearly 12 years (credit to Worcester)! Last year I had an issue with the Diverter Valve so I replaced it and no problems, at the time due to the age I also changed the Overheat sensor, CH Sensor and DHW Sensor. All running fine. Roughly 1 month ago...
  4. P

    Philips DAB Radio wiring question

    I have just bought a Philips DAB Radio, the website info said it had a AC/DC socket, I was hoping to use the radio in my van and therefore I also purchased a cigarette lighter 3-12v convertor. Do you think I could fit a 2.5mm Jack plug socket into/onto the back of the radio so I could plug...
  5. P

    Philips DAB Radio wiring question

    I have just bought a Philips DAB Radio, the website info said it had a AC/DC socket, I was hoping to use the radio in my van and therefore I also purchased a cigarette lighter 3-12v convertor. Do you think I could fit a 2.5mm Jack plug socket into/onto the back of the radio so I could plug...
  6. P

    Mixing Ariel Cables?

    The issue I have is that the Hi Fi signal in my lounge is not very good, I have got ot connected to a 2 outlet patrease TV + FM. My question is: Can you run the FM signal down the same cable as the TV? I currently only have one cable going to the outlet. I do have a FM Ariel and TV Ariel...
  7. P

    Worcester 28CDi

    Hi guys (and girls..) I have had a Worcester boiler in now for 10 years, it runs very well, just had a check over, I have noticed the relay contacts on the pcb are very black, I relise this is due to a small amount of arcing on start up. I'm thinking of replacing them before they take out...
  8. P

    Worcester 28 cdi

    Hi People, Please could somebody advise on if the hot water flow rate can be adjusted for a faster flow. A friend who has the same bolier has a much better flow rate even though the house is bigger. Somebody... has said that you can ajust the flow rate? Heating is fine. What is...
  9. P

    Replacing Thermostat

    I shall be looking at replacing my thermostat for a new one, not sure exactly on the connections? Old model is a acl drayton, 4 wires connected, Red, Blue, Yellow and earth. New one is a sunvic tlx9201 also 4 wires, problem is the labeling is different! 1= Com, 2= Satisfied, 3=...
  10. P

    Thermostat replacement

    I shall be looking at replacing my thermostat for a new one, not sure exactly on the connections? Old model is a acl drayton, 4 wires connected, Brown, Blue, Yellow and earth. New one is a sunvic tlx9201 also 4 wires, problem is the labeling is different! 1= Com, 2= Satisfied, 3=...
  11. P

    Decking spacing

    Have just had some decking delivered, its the pressurised type? Some web sites say when laying them 'Put them together to allow for shrinkage' other web sites say to leave a gap between 2 & 5mm :? Many thanks in advance!
  12. P

    Outside mains wiring

    Hi Guys, I recently had an extension on the house, all the electrics were signed off. However, i put a provision for powering outside decking lights. The power is ready to go, could someone advise if i need to use Blue flex when running to a IP67 Junction box where i shall be putting the...
  13. P

    BS For single core colour coding abbrevations

    Please could somebody advise on the latest color coding abbrevations below are correct Black BK Brown BN Red RD Orange OG Yellow YE Green GN Blue BU Violet VT Grey GY White WH Pink PK Turquoise TQ
  14. P

    Resistor Size

    Could anybody advise on what size resistor should be used :?: I am wanting to use a sounder to be wire in with a 24v DC output. The sounder is a 12v DC with a current of 8mA
  15. P

    Size of flexible cable

    I have a single phase motor with a start current of 25A and a run current of 6.5A, I am currently using 1.5mm Flex, is this the correct size flex? :?
Back
Top