Search results

funny you say that, it had crossed my mind. No i wasnt, and the tape present looks rather clean and bright. I spoke to them again today. Whilst reading out section 14 of the 2002 regs (thanks TeesdaleSpark), I then stated that I dont see how 3 small peices of tape dug out over almost a metre...

Thanks for the posts guys. Ive now seen all the evidence they are using against me. There are three small peices of yellow plastic present in the metre wide hole that they excavated in order to repair the damaged cable. given this the company are saying that protectice tape was present. thus...

is the coolant level correct? If there isnt enough coolant then it wont reach the heater matrix.

Thanks guys. It seems a bit of a grey area really. just because the installation met regs at the time doesnt mean they would meet current resg today, and clearly todays regs are in place for good reason (probably because too many people where chopping through them with spades :roll: ). I...

yes I had already thought about that ;)

Hi guys. a few weeks back I was diging in the garden (digging to find hte start of the footings to our house) and unfotunately put my spade through the mains cable to our block of houses. Now, when we first called eastern electricity they said that because it was outside the house we...

The ball valve in our loo makes one hell of a racket, Ill look into that. thanks

It depends how much it opens before getting stuck. Youve now seen how much water flows through it when it opens, so try removing the ball (hold the valve closed though!!!!), flush the loo, then let the lever drop all the way down to the bottom to see if the extra travel gives you better flow...

yeah, its a bugger when it gets so bad that the bottom half falls out preventing the draw from being opened at all :roll: I assume its one of those types of draws that has a hardboard panel which locates in a recess all around? all you can do is run a thinish wooden support underneath the...

Thats a great idea! I never thought of doing that. thanks Damo

maybe the ballcock just isnt dropping properly. Possibly it weas replaced at some point but with an incorrect one, and its being restricted in some way. I would whip the top off the cistern, flush it again. whilst its filling, look to see if the ballcock appears to be moving correctly. If not...

Hi peeps, This is my first post on this forum, so go easy :) Im looking at buying a power mitre saw but dont have a huge budget. The Erbauer 10" sliding mitre saw (129.99 from screwfix) looks good value and seems to do what I want. I know you get what you pay for and I have fallen foul...