Search results

Have engineered I beams (wood flange top and bottom and chip board in the middle). He cut through it to run a shower waste pipe, I can't take a picture just yet but he's cut the entire top flange and taken a 2 inch section out and cut about 30% of the webbing. To top it off, there's an inch...

Removing electric shower, putting in a Stuart Turner 3 bar shower pump instead. We have power for the shower running into the consumer unit with a 50 amp breaker and 30mA RCD. Can this be used to power the pump (on a 5 amp spur)? No pull cord but there's a chunky switch in the airing...

Girlfriends dad is going to be redoing our bathroom for us. We have a Triton T70 GSI (https://www.tritonshowers.co.uk/media/custom/upload/File-1427991224.pdf) with a cold only feed. He insists this shower has a pump built in and that all electric showers do, I'm not sure if it does or not as I...

We're redoing the bathroom. We have low pressure system (gravity fed vented), top of tank is about 1m above the shower head, 6 to 7L per minute flow rate (at the bathroom tap). Currently we have just an electric shower (not power, no pump) cold water fed (15mm pipe from tank). Pressure isn't...

Have had an issue where the heating comes on when it should, but gets stuck on when the timer and thermostat turns off. Boosting the hot water and then turning it off again always fixes the issue. Found out today that the actuator sends a signal to the boiler and pump to turn on, and this is...