Search results

Cheers

Just looking at this as putting another deltabell X at rear Do you still have the link 0v to t on both boxes

Will do that's better as can use same fob not a dedicated one Thanks

just sorted it Programmed a Prox fox with Area B works fine Thanks for all your assistance

Ok I was sill works after change should of set upstairs on keypad with area B for bed set it with A code and b works great can i program a keyfob to be code and B all in one go just offer it up

Ok timed worked for setting, but changed pir upstairs to area A and when set with A it goes into alarm mode when pir sees me

Thanks will do some changes

Hi I have 2 keypads 00 downstairs areas A+B 01 Upstairs area A I have all downstairs set A+B and one Pir upstairs set A only when i set from keypad 01 upstairs it wants me to exit via the exit zone 01 set final exit as should be Can it be set up to set only area A...

Sorted Very Helpfull Thanks Now i can move on to my last item Twin Alert Hope I can do better on that

PGM O/P {0001} Fire

PGM O/P 1= Fire

Put bell output back to 0014 Where do i set eng relay

Change outputs Endstation outputs Bell O/P 0059 Engineer Access Shoul I be Able to meter open and closed on the N/O contact after the 1111 Code is input

sorted tamper switch on box not flat so was not off

No it does not I not sure what else i have done but got SAB tamper now also

Hi I have set up my new alarm system Pyronix Euro 46 Version 10 on the bench before install and on fitting a Deltabell X with Lightbox setup as Photos attached it rings the bell sounder on entering Programing eg 1111, I have also programmed the hold off to 0059 and connected to NO and linked 0v...