Search results

Hi My hot water takes ages to come through, does anyone make an inline pump to speed things up? Ta Peel

Hi Can any one tell me what sort of gap I need to leave around my boiler when boxing it in? The boiler is an Optia FF50 and the top and bottom of the cupboard will be left open for ventillation purposes. Thanks Peely :roll:

Hi I have recently fitted isolation valves in the feed and return to my Optia ff50 boiler, I also replaced the pump at the same time. The boiler now runs for a short time (30 seconds) before cutting out, it then sounds like water is trickling into the boiler, after about 5 minutes the boiler...

Hi I am currently planning a new kitchen and was planning on fitting a extractor hood I was wondering how close to a boiler vent can I fit my hob extractor vent? Cheers peely :roll:

Hi I am planning on laying an engineered wood tongue and groove floor on my entire ground floor. Will I need to use a threshold going into different rooms or can I lay it throughout, kitchen, hallway lounge etc.I was also wondering if it will be ok under kitchen cabinets thanks for your...

Hi I currently have the ceiling removed in my kitchen and I am planning to run a cable from the boiler to the hot water tank, future controller position and pump in preparation for a Y or W plan valve and thermostat and controller etc. (we currently have a set up made by Mr Heath and Mr...

Hi How many rads could I run off my optia ff50 boiler, plus the hot water? I have six at the moment and the system seems to cope fine. I was also wondering if it is ok to use micro bore pipe to fit the new rads as it appears to be a bit more flexible to run in. Thanks peely :roll:

:?: Can hot and cold water pipes be chased into the wall and plastered over? Like ring main cables. Ta

:?: Can hot and cold water pipes be chased into the wall and plastered over? Like ring main cables. Ta