Search results

  1. A

    plug in LEDs

    Hi, I want to install a couple of LED lights via a switch in my bedroom. These LEDs are designed to run from a plug. The transformer, 240 to12v is integrated into the plug. I wanted to chase these lights in then piece up a switch. Will this work with the transformer permanently plugged in. I...
  2. A

    Shower plumbing

    Hi, Ive run 22mm pipping from a tee just above my hot water cylinder. This travels up one metre along loft space then down to shower. Am I likey to have air lock/trapped air problems with this set up?????? If so , any suggestions
  3. A

    pull switch alternative

    Is there an alternative to ceiling mounted pull cord in the bathroom zones??. I have considered a PIRsensor. I already have a cord in the ensuite in which im working, and didnt want another, also I cannot piece into the existing cord which operates extractor. I also didnt want the standard...
  4. A

    40mm and 32 mm female iron

    This is what I was told to ask for. In fact I am coming from my basin and shower and NOT wanting to install traps because I have a hepworth VO self sealing waste. I cannot source a plain old connection ..... Any ideas????
  5. A

    air admittance valve

    I am running 6m of waste from en suite basin and shower, I have been advised to put air admittance valve near basin to avoid siphonage etc. What size in length and bore would this have to be ??, can it terminate in loft space directly above ??. It seems a 110mm air admittance valve used on soil...
  6. A

    power shower fan and light

    Ok, What about this one. Can I power my extractor/light and power shower all from the ring main spur via the same pull cord switch ??. I know usually one comes off the lighting circuit for extractors, but as a switch is needed for both power shower and extractor I was wondering about combining...
  7. A

    Power shower on combi

    Apologies for this much discussed topic. However as I am fitting a power shower to my gravity fed system, would if be feasable to use it in future if I install a combi, I was thinking I could disable it at the fused spur and let it run as a standard unboosted mixer. Mmmm
  8. A

    En-suite waste

    I'm intending to install an en suite shower and hand basin. The waste run to soil stack works out at around 6m with a 90 degree bend in the middle. As far as I know 40mm waste is restricted to 3m runs, 50mm to 4m. What on earth is the solution apart from not doing it ???
Back
Top