Search results

Yes it always starts normaly

I've not seen anything inside the house.. then look for stop cock in footway outside

standard doughnut washer about £1.40 their are around 5 styles in this and is most certantly your problem

After using the shower water turned off, I find the boiler still operating with no flame. The fault leds show 60 70 flashing. The fault finding page in the manual, states Anti frost mode on (burner and pump in operation), but there is no flame’ and sometimes during the day the boiler starts up...

Example: after using the shower, I find the boiler still operating with no flame. The fault led’s show 60 70 flashing. The fault finding page in manual, states Fan off, but air pressure switch fails to return to off position. Is this the answer to my question The other problem I have is led...

I have been quoted £230.00 and was wondering if this is what is the going rate or should I keep looking for a better price

I dont know unless your tring to make a baby then it will be two balls and a bit

Hi David Yes. It is a straight swap but the old one is imperial size so miner alterations are needed. I have drained down as it was leaking badly

What price should I reasonably pay for a replacement radiator and valves?

Onetap has given you sound advice. The leak is UNDER the screed floor, with multiple further layers on top! You have no choice but to find and repair even if it means cutting away as little of the floor as possible Or re route it either way you have some problems Do check that is not at the...

Hi Wolverhampton it’s a bit too far for me to come and help These pipes are normally steel threaded ranging between ¾ & 1¼ and then different sizes throughout the house If the leak is in the cupboard near to the meter you will need to get to the base of the pipe turn the gas back on paint...

Can anyone help me with making a stair case for my loft space have small budget

I presume that you did all of this during the wet weather and then roofed soon after. Concrete takes longer to dry out than you might think, and laid laminate on slightly damp floor although you have put in place, d.p.m. Did you leave enough expansion around the edges? Dampness and expansion...

Is your new floor concrete? How soon after did you place laminate? :roll:

slugbabydotcom Heating is on. Answer: YES You. turn hot water on. Answer: YES Hot water demand is satisfied when you turn the tap and off. Answer: YES Your diagnostics! Instead of shutting off by the HW flow switch it shuts off by the thermistor as the flow switch is stuck on...

see if the secondary heat exchanger in not blocked as insufficent flow will cause no hot water

Rob the fault seams to occur when the hot tap is used this shuts down the heating when the tap is turned on and of again the heating comes back on

Rob Is your description of the diverter valve the central heating control thermistor or the three way valve?

kevplumb ho dear! You.ve put my nerves on edge

Rob if CM stands for chaffoteaux & maury then your right on the ball