Search results

Thanks again Working top man

Image

Hi Stem sorry to be a pain but opening up the Tado receiver but there are no links am I just to connect as above thx

Thankyou so much Stem much appreciated

I have a center (which I believe is a honeywell 707 clone) thermostat wired to a Baxi platinum 32 combi. Do I take the four wires from the thermostat and simply wire them into the Tado wireless receiver

DBrown would you be willing to part with your old ones. Have tried using same from Eurocell but are snapping my guttering rails.

cant replace ring type make flush spot lights into ceiling after pulling out becauuse of water leak can ne 1 describe how 2 refit holder into hole spring clip asembley

recently changed cord to ceiling pullswitch. supply L/N load L/N neon connected to load when pull switch on neon glows Turn shower on neon goes out and no indiator on shower any ideas ....i need a wash[/img]

cheers

shower indictor neon has become disconnected from main switch how do i rewire the wires back have load L/N and suppy L/N

do i turn off the combi at the mains.....do i not have to prime it again once ive ran the hot tap when water off?

forgive me if this sounds stupid but i have a combi heating system do i just turn off the mains to change taps.

I take it thats why it was the cheapest quote

would like to have a radiator fitted to go into new Conservatory but heating engineer has said that new regulations forbid this is this true or is he just fobbin me off to keep the job simple

Recently put up new wall units in kitchen but her who always knows best says there too low.Is there a standard height between worktop and bottom of units that should be followed or is it 'what suits' goes. :evil:

Lifted a couple of floorboards (ground floor) to reveal that parts of sleeper wall had been demolished in places to insert ducted air heating system, obviously done when house was built in 1979.Inserted wooden wedges between joists and sleeper wall to support floorboards. Really bodgy job by...

builder said my bouncing floorboards need slate wedges inserted any ideas why.

Really springy floorboards cds even jump nothings been lifted any ideas ?