Search results

Take the tap head off and take it to a proper merchant, they'll stock them in pairs.

Tepid water- thermistor first check

i recently fitted the tap with a new basin. It was fine, then the customer rang to say it was constantly running. I went back and yes it was. I spoke to Bristan whose technical team refused to speak to me at first. I checked the sensor and that was working well. The tap was away from reflecting...

Thanks for the electrical side but it's the cylinder side I'm interested in. Easy instal it says, is it that easy it can be strapped onto a cylinder like a traditional cylinder stat? It can't be fitted over a immersion heater with the probes inside the pocket where the rod thermostat is. From...

ive been asked to fit a "intelligent"(I'm obviously not), electronic dual thermostat. Absolutely lost on the installation manual. Need to see a picture of one already put in. I'm assuming the probes go where the immersion stat goes.

I assumed the pump was fine as the other rads get nice and warm, I agree I do think over soldering, Not sure where the manifolds are but will try to find them and double check for the kcuf up with the F & R- got to admit didnt think of that one! Thanks for that!!

Also forgot to say, this rad has always had this problem according to the customer!

This only happens to this rad, the others do not cycle so I doubt the bypass.

Hot water was off.

Yes I switched all radiators off but the effected one, not sure what you mean by the bucket test Agile. By the way its a a pressurised system. Hope this helps. :oops:

Hi, A customer called saying that a rad wasn't working on their system. The system is 10mm microbore. Initial thoughts were balancing, so tried to force it to force heat into the system to no avail, rad only got luke warm at the top with what looked like the rad being classically sludged up...

Er- what small claim??????

Has anyone come across this boiler before? The manufacturer is IMI heating, which does not exist anymore. I have managed to get installation instructions for ia 185 but the manufacturers on both are either RSA heating or Baxi....so I'm a bit confused (as usual the customer does not have the...

Just a thought, are the pipe sizes all the same or are the upstairs in 15mm and downstairs in microbore?

You could try turning all valves off except the two that are cold to force the hot water to them. Like the previous post if they dont get warm after taking off the trv heads (dont forget to open the lockshields fully), you will need new trvs. If they do warm up, open up the other valves to the...

Phone is out of charge so cant post a picture, its a male-male three quarter inch connector.

The threads have not been stripped and the connections were on square

Hi, The dishwasher connection(the end that is normally connected to the dishwasher with the rubber washer in it) is blowing off the compression fitting. The compression link remains in dishwasher link to cold water/ The only thing I can think of is to put loctite thread on the threads.

I am at my wits end. My dishwasher is on an extended hose and is linked by a compression fitting ti a bosch dishwasher. It was fine for a few months, then the hose blew off the fitting! I had PTFEd the plastic fitting, as required and was shocked when this happened. So I changed the fitting...

Hi, A customer has a shower mixer tap, where the water is either roasting hot or freezing cold when the shower is used. I went to have a look at it and it is gravity fed hot and mains cold. I had a look at the installation, no isos and no check valves. When the shower is on for a period of...