Search results

Sounds like its knackered, there are issues with these units. Turn the power off, remove the cover from the sender unit and you will see wires in to terminals 1 & 3. Put both wires into the same terminal and your heating should work again until you can replace it. Control the heating by the...

Look on showerdoc website and post the pic for a free identification and part number

Almost any shower hose will fit. You will get one from your local plumbers merchants or DIY store. The size is 1/2 inch BSPT and you will need to measure the length of the old one as several lengths are available. I forgot to mention - unscrew the hose from the shower and check the rubber...

The pressure when the system is stone cold should be just above 1 bar. As the system heats up the pressure will rise as the water expands. 2 bars when the system is hot is quite normal. Steve

Have you checked for a leak yourself? Close the stop cock and see if the disc in the centre of the water meter still spins. I replaced a main last week because the water board told the customer that they had a leak. Once dug up the leak was from where they had installed the meter and joined...

My misunderstanding, I thought you said they WERE quarter turn taps :oops: If they are similar to the the taps in the photo a standard 1/2" tap washer should suffice. Steve

Sounds like an air lock to me. Use a wet/dry vacuum on one of the cold taps with the others closed. There are other methods but I have found this to be the quickest. Steve

At least 50 different typs available. Take the insert and the tap head with you to a good plumbers merchants.

The make and model of the boiler that you have has a lot of relevance. The manufacturer will state the ventilation requirements. Having 3 vents in the wall and 1 in the door means nothing without stating the free air space available. My best advice would be to ask you RGI next time you have...

What boiler is it and do you have a hot water cylinder?

[email protected] please send me the power point. Thanks Kirk

You could wire the ch on in the existing programmer to the live terminal. This will leave the ch permanantly on and then allow control on the new RF programmer.

Yes thats right. You will leave the hot water on timed and the heating on constant on the existing programmer

Why don't you fit a wireless progammable roomstat and solve both problems? Take a look at the Honeywell RF programmable room stat. Steve

Did you vent the pump when you filled up?

He means does it run on natural gas (Do you have a gas meter) or Liquified propane gas (Do you have a large gas storage tank in the garden that needs refilling)

Try running it without the shower hose attached, it might be collapsing when hot and after it has cooled it works again. Simple I know but worth a try. Steve

The answer is to cap off the pipe that the fan was attatched to and refit the fan elsewhere.

Hi Place the basin and pedistal in position and draw round the bottom of the pedistal. Once removed, you can drill the holes through the floor just to the rear of the flats at the rear. This will alow room for the wast to pass through the middle and also keep the pipes out of sight. Hope this...

Shut off the power supply to the boiler and isolate all the valves under the boiler overnight. If the pressure drops by the morning, you have identified the leak as comming from your boiler. If not, start looking at the rest of the system. Good luck Steve