Search results

Hello I will be tiling our dining/ kitchen and hall floor soon. I want to install underfloor heating in these areas and am currently looking at heating mats/ribbon , to warm the floor tiles and take the chill out of the floor ,( not too worried if does not heat room up as a radiator would.)...

I am removing non load bearing partition wall between kitchen and dining room ,which has a radiator on this wall. House is 4 years old , with a Potterton combi boiler , with overflow tank in loft, and flow and return pipes. The radiator in question has plastic flow & return pipes from wall...

Everytime it rains there is a smell of wet plaster in a corner of a room downstairs. House is only 3 years old , cannot see any obvious holes outside - windows and pointing seems ok , although there is a gap for airbricks above the windows. Any advice much appreciated. Barry G

I am installing fibre optics in a bedroom ceiling shortly. Will wire the light source and new light cable (for a new light switch) into the light circuit , using a 4 terminal 20 amp junction box. Am I right to assume that if the lightsource is 50 watts and the mains voltage is 250 volts , there...

Have a mixer shower on bathroom taps. Plan to install new mixer shower tower at other end of bath. The pipes to the bath taps are 22mm copper - plan to install plastic reduced compression tee in each of these pipes under the bath and run plastic 15mm pipes under bath , into stud partition wall...