Search results

Now I know what I am looking for (heating partial load) I have set it to 10kwh as we have 6 radiators, that's allowing 1.5 per radiator....

It says Auto under D0

Hi we have just had a Vaillant Eco tec pro 28 fitted to replace our aged Biasi, and combined with our old Honeywell CM67NG programable thermostat. BUT when the thermostat kicks in and asks for heat from the boiler, the radiator symbol and flame symbol appears on the boiler display, but he...

I have just been ordered to install a composite sink by her indoors :D It will go in a nice new worktop which is not the issue. It is left or right hand with slight cut outs on the underside for the taps to fit. How is the best way to remove the cut out??? Do I drill it with a hole cutter...

I wonder if anyone can help??? I want to fix a wooden baton to a concrete post, so I can fix my gates to the baton. Can I drill 3 holes in the centre of the post without splitting the post? starting with a small drill and working up to the size required. I intend to put bolts through with the...

Hi I have a new 600X600 radiator in my bathroom, it replaced an old one that always needed bleeding (cold at top warm at bottom, lot's of air inside) I thought it was due to internal corrosion because it was an old radiator. I have fitted a new radiator and this one is doing the same, it's the...

I have just checked the doors/frame and teh rest is quite square, apart from the door that closes that has the concave bend in it. It is also present on the glass beading edge of the frame as well so it look likes its the door frame that is bent!!! Not being too well up on thease matters I...

I wonder if anyone can help me?? :( We had a new conservatory fitted last year and I have been unable to get it to seal where the two doors meet. On very close inspection it appears that the door that opens is slightly concave about 75% down the door, by about 1.5mm. This means it's snug at...

It's the "top" ones that move the door in an elliptal circular movement, they have an alen key fitting in the middle that is made of plastic and seems to strip when you try and adjust it......

Hi we have a conservatory (Rehau) and I am trying to adjust the excentric cams on the door hinges. I am using an allen key that fits, but have managed to round the contacts in one of the hinges :( Before I totaly knacker every hinge, is there a special tool for doing this or am I missing...

I have fitted a Honeywell CM67RF to my system, and just wondered do I have the boiler on max heat, or a lower setting? Is it best to have it mad hot or lower temp with the water circulating more.