Search results

Thanks for your speedy reply, I do already have the manual, but cannot find in there how to set the system current time..

Hi guys, can someone offer me some advice please, I have a UAI tower type recorder, running Leviathan, I have managed to sort of get to grips with it, I have set the time and date on the Leviathan system, I`m guessing that Leviathan is running on a Microsoft program and I can`t seem to find...

All done, didn't default, slowly worked through the manual, its tough going to make sense of it all, the panels all connected and on test left the bell off just in case lol....

I am nearly there, down to just one tamper fault and I think I know where it is, hooray, just got to figure out why I can`t replace a sensor with a link without it coming up as a tamper fault.....

Decided against the default, I`m just working my way through the programming, changing some names, users, because I`ve relocated the panel I now don't need all the zones, just got to remove some, struggling with the tampers, did have 9 tamper faults, got it down to three, but cannot find the...

Can someone please help me with defaulting a Galaxy 2.12 panel to factory settings, I followed a instruction I found on here, but sadly it didn`t work.

I would say that the drainage run is quite old, when I say that the out going pipe is higher, I mean only by approx. 2 inches, I can see the bottom of the chamber and its the open channel part of the drain is lower, just a note to say that this site is a commercial site, we are the only property...

I have a query, Not sure of the best way to describe it, but here goes, we had a modular building installed on a plot of land, the waste systems,ie toilet, sink etc were connected by the builders to the drain, this was about three months ago, the drains blocked back to the toilet, I fetched up...

Thanks for the advice, I`ll get some proper cable.

Hi, just want some thoughts on using cat5 cable for the hard wiring of a burglar alarm. I have a couple of boxes, plus I want to alarm my two sheds, prob about 10mtrs, if the cable is acceptable I would run it in conduits, whats you`re thoughts..

No pm received, found a problem with my message settings, I have sorted this out, can you please try again, Thanks

Hi Guys, looking for some advice, I have a ex ADT Galaxy 48, I have it working on basics but it has all the programming for its old location, how differcult would it be to crash the panel and start again.

Hello all, need some advice, just moved house, while putting stuff in the attic I noticed that you can see daylight though many of the tiles, the roof is tiled but has no felt, it has a mortar type bedding on the edges, a lot of this mortar has fallen off, I am going to refil the missing mortar...

Anyone know of a supplier for veritas in the west midlands??

I have a couple of aritech panels, I currently have one on test, just really want some feed back on whether or not to install, are they consistant, reliable, any thing, good or bad??. regards, mick..

What would be the maximum sized trip i could use on the 6mm cable??

if I were to install a new consumer unit in a garage which has a 100amp main switch supplied by means of 6mm armoured cable, could this cable be connected via a splitter to the incoming supply of the house,

Trying to find information on PC cards and how they perform and how good the cheap are from china??

Three cheers for Breezer, he`s the man and a sense of humour too....

Thanks for the info chaps...