Search results

Thank you Namsag, you cracked it. I ran a new cable and it hummed louder. Tried again after much blue language and it worked. Many many thanks.

Second one brand new, first should have been but cannot be certain (ebay). Sounds like I should return the second one as faulty and get a replacement.

Same model pump, I can hear the solenoid click when I turn on the tap, then it just buzzes just like the replaced one. Uses mains not low voltage, cable is protected from water access.

My Showerforce 3 bar twin shower pump buzzes when I turn a tap on but will not run. Situated within bath panel below level of cylinder (no room near cylinder), 22m pipes. Inlet head = 2.3m, top of hot water cylinder to bottom of cold tank=1.3m. Have replumbed pump outlet straight into bath...

Gentlemen, thank you, all my queries have been answered.

Thank you. A plumber advised me that it MUST go next to the hot tank so it could push, not pull, the water. This is the manufacturers recommendation, though I don't understand why. :P

I wish to fit a pump to increase hot & cold pressure to my bathroom. Manufacturers say the pump should be near the hot tank but there is no room. Does it matter if I install it on the floor in a cupboard in the bathroom ? The height of the inlet water pipes would be virtually the same as if it...