Search results

sorted thanks Used a hacksaw blade as per MOTTIES suggestion

Anyone know how to remove these drawers before i destroy em Spring Dont seem to push in , thanks

I am buying a blow lamp for my son He is pretty handy , plumbing and car mechanics were some heat might be needed Could you suggest any I dont know what gas to use propane or whatever thank you

i need to change the close coupling kit on the cistern Its leaking bad now Thing is the wing nuts are in a right state and i cannot get to one side to get a hacksaw blade in its right against a wall I wondered if it would be easier to remove the full toilet ,which looks a bit easier but heavy...

B60SCWX Cooker outlet on the wall with dedicated circuit . Just been completely rewired thanks

Could you tell me what size cable i need The cooker is a BUSH B60CWX freestanding argos many thanks charles

Yes it did long stalks with seed heads I cant going digging out im to old for it It killed me getting this far thanks

The damned thing was over 2 metres tall and just to much for me at my age I have shifted all the top growth and wondered what is best for Levelling of to near ground level I can shift the round top coping and pebbles to get more access but the rest no chance thanks

I have removed the cold water tap cover to put new washer on but i cant shift the hot I am frightened of smashing it Any advise please

I am just relaying some laminate floor in the kitchen and wondered if i could help it resist any spillages around the sink area between the tongue and groove eg, pva or silicone It is good quality and says it has some resistance Thanks

The top has been wet and dried down but there is various layers of stain varnish If i stain to desired colour am i best using a acrylic finish I am worried about spraying with standard solvent based aerosols

not a clue It just all looks a bit shabby or am i being picky

Hi i have just had a new roof finished today and before i pay i would like a roofers opinion about the way the lead is finished near the chimney and the the bonding gutter Mine is the roof with the aerial thanks

Anyone know the difference or opinions between these two models thanks

Thanks .Just helped me decide I have some spare tiles I will take a couple off and patch up as needed after getting pipes in Never thought of going through the other side but to be honest that would be a job as well to finish off with what would be needed

I want to install a mixer shower ( mira atom) I need advice on the best way to tackle it see photos I dont really want to remove any tiles if possible because they are stuck onto lath and plaster I have some room under the bath as can be seen but which way to route the hot and cold (n) any...

I have a ideal logic c30 a year old and would like to put in a mira atom mixer shower I normally have the hot water set to 58deg Would it need uping to maximum for a decent shower and is the boiler and mixer a good " match" thanks

thanks i reckon i can do that

Hi can i change the washers without turning the water off on this tap I have no isolating valves in the bathroom and i didnt want to mess with my new combi boiler thanks