Search results

I tried adjusting the cam roller but it was already on the max height - eventually had to adjust the main hinges - took the door up a few mm in height and locks perfectly now with no force.

does anybody know if the window pane will have to removed to fit this type of e seal in its groove or can it be push fit from the outside. hoping its the later as the window unit is massive.

Hi all, we have a upvc front door that is hard to lock. when the handle is turned up to engage to hooks and bolts it takes a few goes and a bit of force before I can then turn the key in the lock. when the door is open and the handle is turned up all works ok and door key will tun no problem...

sorry didnt get a photo but it is like this

its round the rental house, going round in a few hours so I will get a photo of it but I think its an E shaped profile - do these exterior seals just push in from the outside or is it a take the window out job to get it in the "groove"

Hi, hope some of you with more experience can help. We had ivy growing up front of house and when removing it it had managed to attach to part of the upvc window exterior rubber seal between the beading and window and pulled it out. The window is a massive single pane of approx 7 foot x 3 foot...

yes it is, they are both varnished with the same PU varnish but the only difference is the age

the left door is about 15 years old - right is new as you can probably tell lol right door has 1 coat of oil based pu satin - same pu as other

Hi, definately oak, I can tell by grain

Hi all , we have replaced a oak door on the landing and I have put 1 coat of varnish on but its no where near the colour of other doors which are a nice orange shade. Can I use coloured varnish to bring the colour to the others

here is the colour difference - would an antique pine be ok

Hi, I have a new oak veneer door which I have varnished but its turned out no where near the colour of the other older oak doors which are more of a golden/orange colour. Can I apply couple of coats of a coloured varnish or stain to get it near and then varnish over this.

I have made a fire surround out of pine sleepers and after 4 coats the wax I have used (fiddes rugger brown) really doesn't go with my other furniture which is a shame as its came up lovely?. I have decided to strip it all off and apply a red/brown stain first then wax as with the wax on...

Paint, that explains it I thought it was for any finish.

thats one thing I never understood about knotting solution, how are you supposed to get an even finish if you just put it on the knots ???

I presume it being pine and a fire surround that the knots are going to weep so I was going to have to treat them with knotting anyway so would treating it all effect the wax coats going on after using fiddes ruggarbrown. Or would it be best just to wax it all no sealer no knotting?

Hi all I am after some wood finishing advice for pine, I am building a fire surround out of pine garden sleepers (non creosote) I have it all sanded down to 120 and its looking quite good so far. I have decided to wax but I have read in some places that I should coat it in sanding sealer...

Hi, I have had a look at their website etc and inside and all looks well apart from the drums not turning (electrical fault) and the belt has snapped, the inlet is clear and outlet is clear and flows out freely. I have spoken to the other owners and it flows into a field land drain at the...

Hi all, ourselves and 2 neighbours share a Klargester biodisc BC and the land below it is all soggy and water logged but the unit itself is not overflowing its lid and doesnt appear full. Is there another overflow to ground that I cant see that these units have or do they literally overflow...

dont worry the rain will wash it into the soil and the grass will process it like a mini bio unit