eurostar

Hi there, My trianco Eurostar boiler flue has some slight gaps around it. I'm guessing these should be sealed? I have attached an image where you can see a slight gap around the flue 1-2 mm wide. I'm considering using fire cement to seal this gap? Thanks in advance

Hi, Does anyone know if the Eurostar 90 requires a flue specifically for that boiler, or if a generic flue of the same dimensions would suffice? Proving to be tricky to source a flue for this old boiler. So far have found this one... https://www.bhl.co.uk/trianco-1000mm-horizontal-flue.html#...

Hello Oil Boiler Trianco Eurostar Premier 100/125 Condensing boiler. Runs fine for about a minute then flame dies (sounds like the solenoid is closing oil supply) after 7 seconds it fires again and continues running. Fan is running all the while. Cycle repeats until the boiler gets up to...

Hi all, I have a Trianco Eurostar combi 65. When the heating is on, I am unable to get hot water. If I set the thermostat to low temp to turn heating off I can hear the CH valve turn to hot water and it comes through. What’s the issue here? I am getting 230v on terminal 2 when the tap is...