geberit

Hello I think the toilet washer between the pan and cistern needs to be replaced, but when I’ve logged at doing this before in another toilet I couldn’t figure out how. This is what is inside the thing Review on Amazon: Easy...

The system purchased was Geberit DuoFix article no. 111300005 (May 2016), which if I am not mistaken includes the Sigma UP320 cistern. Currently both large and small flushes are splashing the ceramics and toilet seat of a rimless toilet. Does anyone know whether the flush valve in the UP320...

I'm trying to identify which Geberit flush panel this is: I think it is an Omega 20? If this is the case, I think I'm supposed to open it by pulling the right edge towards me, then sliding the whole thing left as per these instructions. But I don't want to break it, and it's not opening...

Hi, I have installed the waste pipe as seen in the attached photo, making sure I have a fall of 1:4 to 1:3 from invert of the bend at the frame to the invert of the 4” pipe at the face of the bend ( the distance is 1400mm) that goes into the outside soil pipe. However, I’ve just seen few...

Could somebody tell me how to remove the plastic circlip and rubber washer from a leaking flush pipe connection at the bottom of a Geberit low height concealed cistern? Also is it possible to do this with the cistern and WC in situ?

Hi, after flushing, my cistern continues to fill to about a cm above the overflow pipe before the water goes down level with the overflow and stops refilling. I guess that means its not shutting off quick enough, but does that mean a faulty syphon unit or faulty float valve?

Hi all, New to the forum so apologies if this has been answered before. I recently had my bathroom renovated and had a Geberit in-wall system installed. It was working flawlessly until last night when I noticed a dripping sound coming from the cistern, It's roughly every second and...

I have a Geberit dual flush concealed cistern (jpg file attached) in the bathroom that has started leaking very slowing into the toilet. My stupid question is "how do I get the flush plate off?" I have tried sliding it up, down, left and right in the hope that one edge will lift clear, but so...