• Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.

multi zone

  1. S

    Hive Multi Zone install on Logic Combi ESP35 boiler

    Hi my very first post so hoping that i can find some advice please. I have read a few older posts relating to this topic but have a pretty quick question i think. Where do i place my two hive receivers? From the research i have done for my boiler and system, which is two zone heating...
  2. T

    Multizone heating issue

    I have a heat only Worcester Bosch 30kw boiler and a 300L Ideal unvented cylinder. There are 3 zone valves, one for ground floor heating, another for 1st floor/loft heating and the last is for hot water. There is only one return pipe for the radiators. I had this and completely new pipework done...
  3. H

    Hive Installation

    Hi I am looking at possibly upgrading our existing system with Hive, Tado or similar. Hive is my current preferred option as I have seen a good deal on an approved re-sellers website. Our current system is a two zone using TP5000 controllers. We have a Gledhill Boilermate SP and GB20 boiler...
  4. C

    How does hive ACTUALLY work?

    I've searched a lot for the answer to this question, so I thought I'd open it up here to see if anyone know how Hive actually works. I already have a Hive hub, and I'm now planning on using hive to control my heating. I only need to control heating as hot water is on demand (i.e there's no hot...
  5. D

    Danfoss TP9000, TP5000 & Smart Heating

    Hello all, I'm thinking of buying either Tado, Hive or Nest for my house. I live in a relatively new build 3 story townhouse in the UK with the Danfoss TP9000 thermostat / hot water programmer on the ground floor next to my Ideal Logic 15 boiler, a Danfoss TS2 sensor in the living room. Then...
  6. B

    Viessmann 200w with Multi Zones

    Merry xmas all I am replacing my creaking ideal mexico with a viessmann 200w 35kw 4 piped. Converting both CH and HW from vented to unvented. I currently have each room zoned off (radiator actuators) via a central controller (Loxone). 6 bedrooms, 3 bathrooms, kitchen and 3 reception rooms etc...
  7. G

    Too many zone valves

    hello Hope someone can help! Fitting Hive thermostats to a large home which has a fully pumped system with dual zone central heating and hot water cylinder running off a Potterton gas boiler. Confused by the three 2-port valves which are on the flow side of the system immediately after the pump...
Back
Top