pvc door

Euro door lock was starting to fail. Bought a new Yale lock barrel to replace it. Unfortunately something inside the operation had come loose and had to snap the old lock to get it out. The new lock has slid in, the new key turns and engaged all the multi points and the door handle...

Problem: There is a gap at the bottom of my PVC door causing a draft, it looks like the bottom needs to move to the left so that it makes contact with the rubber seal around the frame. Attempted fixes: I've rotated the cams on the door and adjust the catches inside the frame but this wasn't...

Hello, I am replacing the euro cylinder in my door, however the hole where the retaining screw goes in is blocked, seems like the mechanism is blocking this. When I lift the handle to to engage locks or open door it doesn’t move much. So no way of getting the screw in to secure the cylinder...

Hi all First time poster here, would greatly appreciate your advice. I need to remove my PVC door for a delivery (after which hopefully I will simply put it back as it was). I've opened the door 45 degrees but it will not lift up! I feel like I will break it if I apply more upward pressure. I...

Hi, The restrictor bar on our pvc patio door has come loose at the end that attaches to the frame because the screws are no longer gripping properly. Is it better to buy bigger screws or move this end of the bar slightly and make new screw holes please? Many thanks

Hi all. I’m very new to this site and I was looking for some advice. My wife has noticed a crack or something within the border panel around the windows in our composite door. She is very worried that someone may be trying to break into the door via this way but I’m not sure, I’m looking for...

I am looking to change the cylinder locks on my French doors. The door on the right is easy to do, with removing the screw from inside. However on the left door, this is not accessible as easily. IMG_20191201_154426 by Phoebian posted 2 Dec 2019 at 8:00 AM From what I can see, this plastic...

Hi All, So I'm a student in a small uni town and the way some of the houses are here have a front door that opens directly into a ground floor bedroom i.e. my room. I've noticed now that the front door doesn't properly seal in the bottom right corner below the handle and it's leaving enough of...

Hi, Looking for a bit of advice. I have been installing laminate flooring in my livingroom and have become stuck on what to do when I get to my pvc door as pictured. Should I treat this as a wall and just lay up to the door, my only concern is the beading will not look right when installed as...