underfloor heating design

Hi wondering if anyone can help we have 11 zones of under floor heating which are linked to 3 separate thermostats. the plumber is different to whoever laid the underfloor so he can’t figure out which actuator / wire links to which thermostat so at the moment each thermostat heats up the...

Hi all, We're currently renovating a Victorian house and are struggling a little with the kitchen floor situation. As we are in a tough spot financially we cannot afford to get any trades in at the moment so please no suggestions on that or i'll cry. As you can see from the picture half of...

Planning to heat a new-build 18sq m extension with wet UFH but without resorting to an off-the-shelf kit. I have several reasons for not wanting to buy a kit - I think they're generally over-priced for what they contain (I've seen standard looking £60 CH pumps thrown in with a couple of...

I want install underfloor heating (UFH) and, apparently, because of the wooden floor boards we can’t use an electric UFH system, so we have to use a water system. But I don’t have a gas boiler to make hot water. There are electric boilers which apparently- according to google- will be ok for...

Hi, I was wondering if there is anyone that can provide advice on my UFH design (attached). Each Run is circa 75m, I have gone for 150mm spacing at the front as there are large bi-fold doors. The top section has sufficient room height to install roughly 75mm insulation then 15mm pipes and a...