I've a 110mm grey plastic soil pipe with a saddle strap glued on that has been fitted below level to connect to a sink basin waste running inside the upstairs first floor. I want to seal the saddle off but don't want to replace the pipe that would involve lots of work. I want to ensure that the hole in the saddle is completely filled upto the inside surface of the 110mm pipe to avoid waste build up and blockage up at that point, any ideas please.
110mm soil pipe alterations
- Thread starter gardener1214388
- Start date
Sponsored Links
Could you remove this saddle and swap it for an access saddle instead? They have a profiled plug inside to prevent blockages and it should theoretically be ok to bury this as per any other joint. Otherwise cut a section of pipe out and replace with new using a couple of rubber slip couplings?
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
