I've read through some other posts on control board fuses blowing but I can't find anything definitive.
The control board has a 3.15A at the front and I think 500mA further around which is fine.
With a new fuse I ran the CH for 15 minutes and all seems well, flicked back to just HW, turned on the tap and within a few seconds the fuse pops.
I couldn't be sure but I would say that the water got excessively hot.
Any ideas?
The control board has a 3.15A at the front and I think 500mA further around which is fine.
With a new fuse I ran the CH for 15 minutes and all seems well, flicked back to just HW, turned on the tap and within a few seconds the fuse pops.
I couldn't be sure but I would say that the water got excessively hot.
Any ideas?