Accenta G4 System wont go through test mode

[toddy123]

Hi all having problems getting through test mode .
so at moment I've one door censor wired to zone 1
all loops are in tamper
I tap program then 9999 no zone light on
tap 0 for walk test
Then all the zone lights come on and bleep bleep continuously

Can anyone help
Thank you

 

[secureiam]

you may find it easier to put links in the zones that are not in use.

if zone 1 is open, then it will be illuminated if the door is shut and magnet in place LED shouldn't be on it could be a faulty wire or device stuck open.

 

[toddy123]

Thank you
this is a new system out of the box, originally i had everything wired up . bell box . pir`s . door censors so on .. so with the fault i had i dropped everything out and wired one door censor only .

And yes things can be faulty from new so i took the wires out of door censor and twisted together to make loop, when i go back out i will put links in all other zones as you suggest

 

[toddy123]

Thank you secureiam
Sorted links installed and all worked.. will do a full test tomorrow once all wired back up