Have bought a place to renovate. An annex to the side of the house is like a cold box and i wish to insulate and rconstruct it.
One thing i am going to do is take out 4 large windows (single glazed) and make stud walls based on existing window construction, which is fine.
Questions are: what board to use outside to render directly onto.
Also i have rendered before with 4:1 mix and used sharpsand. This was fine but would like to know if any other possibilities. Finishes?
I have seen sponge flaots-what finish do they give?
Any advice appreciated. Can upload photos if it helps.
One thing i am going to do is take out 4 large windows (single glazed) and make stud walls based on existing window construction, which is fine.
Questions are: what board to use outside to render directly onto.
Also i have rendered before with 4:1 mix and used sharpsand. This was fine but would like to know if any other possibilities. Finishes?
I have seen sponge flaots-what finish do they give?
Any advice appreciated. Can upload photos if it helps.