Hi
Hope there is an expert who can advise on my problem!
Bought the house 5 yrs ago and the alarm system had been installed when it was built in 1999.
When removing a picture that had been hung above the control panel, the picture fell and hit the panel. The internal alarm went off (what a pleasant surprise that was!!). I entered the 4 digit code and the alarm silenced however the panel now shows a 'fault' light and flashes a code r1. I believe this relates to a 'keypad enclosure tamper', no doubt relating to the blow from the picture hitting the panel.
My question is - how can I clear this code without setting off the alarm again, or should I just leave this well alone and let the 'error' message continue to flash?
Thanks in anticipation of your help.
J
Hope there is an expert who can advise on my problem!
Bought the house 5 yrs ago and the alarm system had been installed when it was built in 1999.
When removing a picture that had been hung above the control panel, the picture fell and hit the panel. The internal alarm went off (what a pleasant surprise that was!!). I entered the 4 digit code and the alarm silenced however the panel now shows a 'fault' light and flashes a code r1. I believe this relates to a 'keypad enclosure tamper', no doubt relating to the blow from the picture hitting the panel.
My question is - how can I clear this code without setting off the alarm again, or should I just leave this well alone and let the 'error' message continue to flash?
Thanks in anticipation of your help.
J