Had pump plan fitted so now got pumped CH and DHW.
Pump is quite noisy (its on 2 for CH - was 3 to start with) but also when it comes on for CH there is a sound of rushing water through the pipes surrounding it and then gurgling in the bathroom towel rail. The top rail fills with air over 2/3 days.
Heating Engineer is going to fit a pipe between the vent and F/E (I believe) and put some leak sealant in system as, of course, the bathroom floor is tiled, and he says the problem could be a leak in the pipework leading to the towel rail as this is the only rad that has been replaced (3 years ago and no problem with old pump).
When we had a rad in the bathroom this often had to be bled but we never heard any rushing/gurgling air/water. The towel rail did not have to be bled at all with the previous pump.
Do you think that he has covered the eventualities?
Not sure what to do if we need to get to the pipework under the bathroom floor. Will never tile a bathroom floor again!
Pump is quite noisy (its on 2 for CH - was 3 to start with) but also when it comes on for CH there is a sound of rushing water through the pipes surrounding it and then gurgling in the bathroom towel rail. The top rail fills with air over 2/3 days.
Heating Engineer is going to fit a pipe between the vent and F/E (I believe) and put some leak sealant in system as, of course, the bathroom floor is tiled, and he says the problem could be a leak in the pipework leading to the towel rail as this is the only rad that has been replaced (3 years ago and no problem with old pump).
When we had a rad in the bathroom this often had to be bled but we never heard any rushing/gurgling air/water. The towel rail did not have to be bled at all with the previous pump.
Do you think that he has covered the eventualities?
Not sure what to do if we need to get to the pipework under the bathroom floor. Will never tile a bathroom floor again!