aquarius wd440 2 lights flashing

[cannonballer]

Hi can anyone help me on this one

The on off light is flashing very quickly and the reduce creases light (I think light 2) is also flashing but slowly...the machine will spin and I can open the door ect but it won't run a full cycle

Thanks

 

[rocks1]

Check the filter and blow down pressure pipe

 

[cannonballer]

Where is the filter? And pressure pipe I'm a noob lol

 

[rocks1]

Filter is at the back under the drum. Pressure pipe is on the back left of the cabinet.

 

[cannonballer]

Thank you will give it a try

 

[cannonballer]

I have took lower panel off the rear of machine and can't see filter or pressure pipe? This is the washer dryer that we are both talking about?

 

[rocks1]

Yes a washer dryer. It's a big black cup under the drum with a jubilee clip round it. Pressure pipe is on the top of the mc , remove the lid it's on the rear left next to the dispenser.

 

[cannonballer]

Found the filter and cleaned that out plumbed it back in and that didn't work...will try the pressure hose now and see if I have any luck with that otherwise I think Its time for a new wahser

What caused the fault was I stopped the cycle just as it stated to put something else in the wash and since then it just won't run

Spins fine pumps water fine but won't run for more than 2 mins

 

[cannonballer]

Is it one of the 3 pipes that go into the dispenser or the grey one with clip on it?

 

[rocks1]

None of them. It's a clear tube that connected to a pressure switch under the dispenser , the clear pipe runs down the side of the drum to the filter which you cleaned out. You could try unplugging it for 5 mins then try it. It might reset it.

 

[cannonballer]

Tried that now as well...

Thank you with all your help with this and even though I didn't manage to get it working I now now what a filter looks like and where most of the parts are so I have enjoyed trying to get it working..

I put it on a rinse and spin cycle after trying everything at filled with water fine...slow spinned fine fast spinned fine and drained fine and ran for over 10 mins before gping back to same fault...but it allways drains the water fine before it breakes so fustrating that all the functions work but just won't run full cycles

But thanks again for all your help

Mark