Hi All
Have had the above system boiler connected to a 'megaflow' type system for 3 years now and its never really performed to its capabilities even though I've set it to use the 100btu capability. Very often it overruns and goes into this anti-cycle mode, which obviously prolongs the duration of the HW and CH demand/recovery. This has been from since its been installed by a 'Gorgi' registered engineer.
I've had other lockout issues in the past and had to swap L and N to get it to work again and this seemed to resolve the anti-cycle issue for some time. I've swaped the L and N around again and still the overrun issue persists. I've had a good look around but before I go replacing parts which could be the cause does anyone have any suggestions.
Many thanks
JP
Have had the above system boiler connected to a 'megaflow' type system for 3 years now and its never really performed to its capabilities even though I've set it to use the 100btu capability. Very often it overruns and goes into this anti-cycle mode, which obviously prolongs the duration of the HW and CH demand/recovery. This has been from since its been installed by a 'Gorgi' registered engineer.
I've had other lockout issues in the past and had to swap L and N to get it to work again and this seemed to resolve the anti-cycle issue for some time. I've swaped the L and N around again and still the overrun issue persists. I've had a good look around but before I go replacing parts which could be the cause does anyone have any suggestions.
Many thanks
JP