I have fitted 2 baxi wall heaters and one will not light i have tried sorting the thermal coupling out but the fault is still there when i release the switch to turn it on fully it goes out. Any suggestions is it likely to be the valve has anyone come across this?
Take the casing off and see if it ignites and holds,if it does it will be the casing restricting the the knob,ie not depressing the "mag valve" enough to "make"
If this is the case simply slide a couple of washers over the gas tap shaft before replacing the control knob,this will allow clearance between knob and casing........all do"uble "entantres resisted !!!
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local