- Joined
- 8 Feb 2015
- Messages
- 223
- Reaction score
- 7
- Country
Hi all
Am replacing a 44mm door with a 40mm alternative. Is it possible to remove and adjust the positioning of the existing door stop/door moulding by 4mm, so the door remains flush against the moulding when closed?
I understand these mouldings are usually glued on, so you could run a knife down the edge and prise it off, but this is an old house, and was wondering if you've seen different methods of attachment?
Thanks very much
Am replacing a 44mm door with a 40mm alternative. Is it possible to remove and adjust the positioning of the existing door stop/door moulding by 4mm, so the door remains flush against the moulding when closed?
I understand these mouldings are usually glued on, so you could run a knife down the edge and prise it off, but this is an old house, and was wondering if you've seen different methods of attachment?
Thanks very much