If installing an unvented cylinder and the cold feed enters the cylinder cupboard at low level. Is the only way to pipe it up to run the cold up then back down to the cold feed enter to the cylinder. Thus allowing the required height to install to presure relief, expansion vessel and comp. valve.
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
cold feed to unvented cylinder
- Thread starter tomsim
- Start date
Yes. Won't cause a problem.
P
Phill Peck
This is not a question you should need to ask
Are you qualified to fit an unvented cylinder if you don't know what your doing they can be very dangerous
http://m.youtube.com/watch?v=61uDmQF5I2E
Are you qualified to fit an unvented cylinder if you don't know what your doing they can be very dangerous
http://m.youtube.com/watch?v=61uDmQF5I2E
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
